Subject: From Roger Date: Wed, 20 Oct 2004 18:18:23 -0700 (PDT) From: Roger Mingle To: carnut@carnut.com Pic# 41 New trans crossmember for Mopar 727 tranny. Pic#42 Looks like it mounts real nice. Pic#43-44 The inner fender panel, brake lines, shift linkage, E-brake cable all trying to fit in the same place. A little triming on the fender panel is in order. Pic#45 Alternator & inner fender panel fighting over space. A large hammer takes care of it. Pic#46 A little clearence for the upper A-arms. Pic# 47 Everything shoved in the hole. Lots of clean-up & detail work to go. Pic#48 This is the final ride hieght where it will sitwith full travel of the front end. Next is to blow it apart & clean & paint & replace balljoints, tierods, ect. Pic#49-50 A couple more pics of the ride height. Pic#51 Part of the radiator sets below the grill so I made some air slots to allow more cooling. I have installed probably 10-15 of these front-ends & no two are the same. This is just a general idea of how it is done. Please dont try this unless you are an experenced mechianc. --------------------------------------------------------------------- [Image] [Image] [Image] [Image] [Image] [Image] [Image] [Image] [Image] [Image] [Image]