Subject: from Roger Date: Sun, 17 Oct 2004 16:30:35 -0700 (PDT) From: Roger Mingle To: carnut@carnut.com Pic#11 After measureing the width of the frame rails, figure where they will sit on the on the sub-frame. I cut a peice of poster board to fit the contour of the sub-frame. Pic#12 I layed a straight edge across & line up with the top zerk fitting. Come straight down off this straight edge & mark the center line on the posterboard & on the sub-frame. In this case the centerline is 1" foward of the mounting pad. Pic#13 & 14 Get the steering box & the motor out of the way. Pic#15 This is what the frame rails look like. Notice where the old fruit jar master cyl was mounted. More on this later. Pic#16&17 Before the I-beam axle comes out we need to mark the centerline of the axel on the frame. Pic#18 This is the centerline of the orginal axle. I marked it with a hacksaw so it wont wipe or grind off. Pic#19&20 That axle & springs are rolled out. --------------------------------------------------------------------- [Image] [Image] [Image] [Image] [Image] [Image] [Image] [Image] [Image] [Image]